YK-998W-4HC
4 HOT & 2 COLD STATIONS BACKPART MOULDING MACHINE WITH FLANGING WIPERS
Application
- Backpart and heel margin flanging moulding.
- General backpart moulded.
Characteristic
- Suitable for all materials better for thermoplastic material.
- The temperature of both the inner and outer part of the mould can be adjusted freely by itself (depending on the material).
- High output, it can be operated in the sewing process for the smooth and preparation of the moulding line.
- The upper pre-moulding make the toe & heel seat lasting machine work smoothly to save material & labor cost and increase output.
- Four hot moulds are suitable for the upper thick or heated under the lower temperature.
- Hot mould was designed to adjust the upper ergonomics matters.
- Positioning board & board & truing-up light device help to get accurate position.
- Cold mould slanting to operator is convenient for moulding.
- Custom-made outer & inner mould offers the highest accuracy.
- Wipers were deviced with selective switch, and can be turn off if not required.
- Adjustable clippers help to cause the fastening of the shoe uppers and last mould to be 1OO% accuracy.
- Purpose designed high power cooling system it can get the best effect of moulding.(vaporizer temperature -2O℃ down).
Dimension
2090 x 760 x 1910
Voltage
220V 1~:50/60Hz
Power Consumption
3.4Kw
Air Pressure
5~6Kg/cm2
Catacity
1400-2000Pairs/8hrs
N.W/G.W
580Kg/700Kg
